Re: Rubik's Cube (DIY speakers??)
Posted: Sat Jan 28, 2023 4:13 pm
Series Wired?? I can see a bit of an issue with what I'm planning then. Obviously with the Cubix, and the Cubix Pro each section is powered by a separate amplifier, either buit in or external. With my design each speaker will have 5 drivers (Three 12" Kenford SBX3040 8 Ohm Bass drivers, One QTX QXW6 6.5'' 8 Ohm Mid Bass, and one Visaton G20-SC 8 Ohm tweeter) in series that's a total of 40 Ohms. The Sub's are/were available in 4 Ohm, but really difficult to find.
I suppose I could Bi Amp them, with the Bass wired 2 in series and 1 in parallel to give a 5.3 Ohm load. Impedance isn't the "Be All and End All" but I don't want to subject the S300 to an "Impossible load". Once you start throwing another pair of S-300's into the mix, to drive each section this project really starts to price itself out of my league
I suppose I could Bi Amp them, with the Bass wired 2 in series and 1 in parallel to give a 5.3 Ohm load. Impedance isn't the "Be All and End All" but I don't want to subject the S300 to an "Impossible load". Once you start throwing another pair of S-300's into the mix, to drive each section this project really starts to price itself out of my league