A40 Mk2 and P50 Burn in ?

AshM750. · Unread post by **AshM750.** » Fri Jan 30, 2015 10:09 pm

I dont think the Dyns suit the NVA, the royds are so much more fun to listen to. I have left the amps on constantly for a week now and there getting better.

Unread post by **Fretless** » Fri Jan 30, 2015 10:34 pm

Try running your P50 with either only the dac in to 'direct' and no other inputs attached. Or inputs only through the switched Sockets and nothing in direct.

AshM750. · Unread post by **AshM750.** » Fri Jan 30, 2015 10:37 pm

will do ile try it now

AshM750. · Unread post by **AshM750.** » Fri Jan 30, 2015 10:50 pm

right OK I have used AUX direct (top rca port) ok but when I plug it into AUX (bottom port) I have got no right channel is this right ? also I have noticed that some recordings are louder than others which also affects the volume. I feel that I have to turn this system up to get a good responce, I do prefer listening to my music at low volumes and it doesnt seem to work very well at low volumes.

I have it playing through CD input at the mo and that seems to be best.

Fri Jan 30, 2015 11:01 pm

What you are saying makes no sense. The top two that are above the normal line of sockets are labelled the direct inputs. They should only be used if you use one input and one input only. More than that connected then use the standard switchable inputs that are the line of inputs under it. You can use any of them as they are all the same just named for convenience.

Sometimes you can use direct with other inputs connected but sometimes depending the equipment used they interact as they are both in circuit at once. ALL direct input does is bypass the selector switch so it is in circuit all the time for ultimate fidelity with a single input.

AshM750. · Unread post by **AshM750.** » Fri Jan 30, 2015 11:09 pm

ok well Ive only had 1 thing in at once the whole time ive had it, Im sorry for the typo but ive been up since 0430 this morning, i meant top Direct both channels work, but on Aux bottom only the left channel works. I will have to go bed as im getting pissed off with it.

Unread post by **Fretless** » Fri Jan 30, 2015 11:12 pm

Better luck tomorrow, Ash

Fri Jan 30, 2015 11:14 pm

Look at it with fresh eyes. If you think the P50 has a fault then send back to be looked at.

AshM750. · Unread post by **AshM750.** » Fri Jan 30, 2015 11:20 pm

Ive got the morning to myself, no Mrs, so I shall start again in the morning.

Regards
Ash

Fri Jan 30, 2015 11:28 pm

Take your time be logical and careful. Frustration and anger is your worst enemy in finding a solution.

A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

Re: A40 Mk2 and P50 Burn in ?

NVA Info

Contacts