Okay , so I managed to get a couple of hours with my still dissapointing hifi. Set the speaker up to the tv to run the speakers in and moved them out of the bay window to either side of fire place ,some 7 feet apart . This was better , watching darts last nite there was a palable sense of the atmosphere of the crowd and the beginings of stereo soundstage.
I did however open the speakers up [ diamond 10.3] and what a horror show.
pcb crossover
tag none soldered connections to drive units
none copper metal junction connections where the speaker wires enter the speaker base .
poor bracing of the cabient and little damping .
Cheap bi-polar capacitors in the crossover
All threse things are throttling the beautiful signal from my TT so I will be undertaking the following modifications and will report back .
1. series wiring
2. removeal of all binding tags .
3. removing the binding post on the outside of the cabinent
4. put the crossover pcb in the bin
5. removing the mid/bas crossover and running one piece of speaker cable from amplifier direct to mid/bass driver - soldered direct on the cone leads
6. simple resistor/capacitor crossover on tweeter , hard wired and soldered to 2nd set of speaker wires with audiophile capacitor .
7. bitumen the sides of the cabinent , adding internal bracing , removing the acoustic foam and blocking the port [ the latter is the only modification subject to experimentation and listening tests]
Question , when i did this previously , the speaker stats were known to me and all drivers had the same sensitivity [91db] , so balancing the volume for the drive units was simple enough. This time i have no idea what the sensitivity of the drive units are . There is a resistor on both the tweeter and the mid/bass currently , is there are way of calculating what resistor value i will need on the tweeter on the new simple crossover, from the two resistors currently employed on the tweeter and woofer , bearing in mind the current bass resistor will be discarded ? Do i simply half the value of the current tweeter resistor to account for the untenuated [?] mid/bass driver or is that to simple /