New 30W Valve Monoblock Project.
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
I can't be arsed to put back all the stuff that has gone, so here is an up-to-date shot of the underside of one of the amps.
The wiring is almost done. Just needs a regulator board for the input pentode screen grids to be installed and the
XLR input wiring putting in. Amp 1 can then be tested and brought into service:
The wiring is almost done. Just needs a regulator board for the input pentode screen grids to be installed and the
XLR input wiring putting in. Amp 1 can then be tested and brought into service:
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
Maybe?
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
After cueing up a few mono records we have music
It all worked perfectly from the off. All voltages within spec and no smoke.
After adjusting the screen balance control of the input stage so that each side of the cathode follower
driver was outputting the same DC voltage and biasing and balancing the output stage, we were off and running.
Niiiiiiiice
The other amp should be operational in a couple of days.
It all worked perfectly from the off. All voltages within spec and no smoke.
After adjusting the screen balance control of the input stage so that each side of the cathode follower
driver was outputting the same DC voltage and biasing and balancing the output stage, we were off and running.
Niiiiiiiice
The other amp should be operational in a couple of days.
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
- slinger
- Posts: 9288
- Joined: Wed Aug 22, 2012 4:30 pm
- Location: The Garden of England
- Has thanked: 4660 times
- Been thanked: 3157 times
Re: New 30W Valve Monoblock Project.
I like the decorative feet. £87.99 each or £192.00 a pair from MCRU, right?
Amps - NVA P50, AP30, A40, Stanislav Palo Tube Headphone Amp BB 85
Speakers - Monitor Audio Silver RX2
Cables - NVA LS1+LS3, SSC, Gotham S/PDIF, IBRA Optical
Digital - NAD C516BEE, SONY ST-SDB900 DAB TUNER, TEAC UD-H01 DAC
Analogue - Pro-Ject Debut Carbon Esprit SB, Graham Slee Gram Amp 2 Phono
Cans - Grado SR80, ATH-M50X
Speakers - Monitor Audio Silver RX2
Cables - NVA LS1+LS3, SSC, Gotham S/PDIF, IBRA Optical
Digital - NAD C516BEE, SONY ST-SDB900 DAB TUNER, TEAC UD-H01 DAC
Analogue - Pro-Ject Debut Carbon Esprit SB, Graham Slee Gram Amp 2 Phono
Cans - Grado SR80, ATH-M50X
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
Yes
The type of paper used in the isolating feet has a significant effect on the ultimate sound quality achievable.
Believe it or not, you can even hear differences according to what font was used for the printing.
Palatino has a slight edge over Times New Roman, but it's not make or break.
Don't tell anyone else, but Comic Sans MS transforms the whole system; you hear instruments that aren't even on the recording.
The type of paper used in the isolating feet has a significant effect on the ultimate sound quality achievable.
Believe it or not, you can even hear differences according to what font was used for the printing.
Palatino has a slight edge over Times New Roman, but it's not make or break.
Don't tell anyone else, but Comic Sans MS transforms the whole system; you hear instruments that aren't even on the recording.
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Re: New 30W Valve Monoblock Project.
Steve, be carefull, they will propably try to nick your description on their marketing
Rega by Michael Lim\Teac\ASR\NVA\
SA Mantra30\Audeze LCD-2 closed.
...the Gods you worship are steel, at the altar of rock 'n' roll you kneel...
SA Mantra30\Audeze LCD-2 closed.
...the Gods you worship are steel, at the altar of rock 'n' roll you kneel...
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
Amp 2 is almost finished.
The photo shows the output stage and screen grid voltage regulator valve all wired up.
Green resistors unterminated at one end are part of the feedback network.
Should be up and running by tomorrow evening. After that it is making a base and feet for each unit
and fitting a knob to the pots between each set of input valves.
The photo shows the output stage and screen grid voltage regulator valve all wired up.
Green resistors unterminated at one end are part of the feedback network.
Should be up and running by tomorrow evening. After that it is making a base and feet for each unit
and fitting a knob to the pots between each set of input valves.
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
Amp 2 is finished tested, biased up and working:
Just need now to make the bases as I said before, but I'll be having a bit of fun later on, trying the pair out in the system, with some music. I sense a late night ahead
Just need now to make the bases as I said before, but I'll be having a bit of fun later on, trying the pair out in the system, with some music. I sense a late night ahead
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
- SteveTheShadow
- Posts: 1646
- Joined: Thu Sep 12, 2013 5:24 pm
- Has thanked: 272 times
- Been thanked: 339 times
Re: New 30W Valve Monoblock Project.
And here are both monos playing via the Sowter phase-splitting transformer equipped passive balanced preamp, built by my son. This can be seen on top of the DAC, behind the right hand amplifier.
At the moment,they are fitted with Electro-Harmonix 6CA7EH output valves.
Niiiice
An enjoyable evening is ahead.
This is what hi-fi should be about.
At the moment,they are fitted with Electro-Harmonix 6CA7EH output valves.
Niiiice
An enjoyable evening is ahead.
This is what hi-fi should be about.
Somebody’s telling me the latest scandals.
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)
Somebody’s stepping on my plastic sandals. Joe Jackson (1979)