Dr Bunsen Honeydew
- Posts: 29975
- Joined: Wed Jul 11, 2012 7:26 pm
- Location: Muppet Labs
We have been doing a batch of A80s and we have a small problem with some of them. 5 heatsinks are 2.5mm undersize, not seen until built so cannot be sent back. Anyway the choice was have the side cheeks protrude slightly, which we decided is unsightly or have the side cheeks bent in to take up the difference. This shows but only if you look for it.
So there are three sets at ebay on a 30% discount, when they are sold the remaining two sets from the batch will be less 20% as the batch cost saving.
Trade-in depends, so ask first with full details of what you want to trade in. Returns warranty etc same as normal.