All general audio posts go here.
Forum rules
1. No ad-hominem
2. No spamming or shilling
-
Dr Bunsen Honeydew
- Posts: 27873
- Joined: Wed Jul 11, 2012 7:26 pm
- Location: Muppet Labs
Unread post
by Dr Bunsen Honeydew » Wed Jan 02, 2013 11:48 pm
Daniel Quinn wrote: is there are way of calculating what resistor value i will need on the tweeter on the new simple crossover, from the two resistors currently employed on the tweeter and woofer , bearing in mind the current bass resistor will be discarded ? Do i simply half the value of the current tweeter resistor to account for the unattenuated [?] mid/bass driver or is that too simple /
The secret formula
-
jammy395
Unread post
by jammy395 » Thu Jan 03, 2013 11:32 am
Daniel Quinn wrote:Jammy , next time your reading this thread could you please compose a suitable Jammy response to Mr Booth and the Doc for me . ta very much
mmmh - would love to scold Mr Booth & Mr Honeydew...........But alas they could have a point............
- Careful - Dan...!!!.jpg (48.1 KiB) Viewed 790 times
Audio DIY can be frought with danger.............Take care Mr Quinn, dont want you ending up like the guy in pic.....2013s only begun.
-
terrybooth
- Posts: 3762
- Joined: Wed Jul 11, 2012 6:49 pm
- Location: West Yorkshire
Unread post
by terrybooth » Thu Jan 03, 2013 9:23 pm
Poetic licentiousness more like
Pioneer PL71/DL103/ Phono2/HiFiPi/P90SA/TIS/CubixPro two-up
-
jammy395
Unread post
by jammy395 » Fri Jan 04, 2013 1:33 am
I reckon the English hifi buffs are a bit of a doddgy lot (only a minority).......
Still Scottish hifi buffs must be a bit thick (only a minority) cause i had to look licentious up...........
-
Daniel Quinn
- Posts: 7075
- Joined: Thu Jul 12, 2012 7:16 am
Unread post
by Daniel Quinn » Mon Jan 21, 2013 12:26 pm
Query -
Does anybody know
a] if there is a term for the springiness of spring ?
b] if there is a direct corralation between the gauge of metal used to make a spring and its springness and the useful weight it can support . ie - is 05mm more springy than 1mm.
I have just purchased some new springs for my TT and whilst they are the correct length and diameter at 1mm thick steel they dont bloody stretch or spring when supporting the subschasis motor bearing and platter . Now i know for the Doc this would be an improvement
, but it just wont do .
thanks
Even a stroke didn't result in me liking AOS
