Page 8 of 13
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 3:16 pm
by Dr Bunsen Honeydew
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 3:19 pm
by Fretless
Here is the Visaton in an MDF Cube 3
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 3:20 pm
by Quarknosis
I would like info on the Chinese Doc Modded tweeter please.
I know it might be a difficult question to answer but how close is it in sound quality to the Visaton's? What improvements could the Visaton's potentially give?
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 3:41 pm
by Quarknosis
Thanks for the pic Fretless
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 3:51 pm
by Fretless
The Visaton is a lovely-sounding tweeter. Smooth and accurate.
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 4:28 pm
by Dr Bunsen Honeydew
They are close but not the same.
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 5:21 pm
by Quarknosis
The current cut out is 78mm so if I went for the Visaton's they would probably have to be glued in because I don't think the screws will be able to get a good fixing into the baffle. Is the faceplate diameter larger on the Chinese Doc Mod tweeters? If not I'll probably end up using some tweeters out some damaged cabinets that I have for the project I am considering at the moment.
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 5:28 pm
by Dr Bunsen Honeydew
Faceplate dia 110mm - hole dia 70mm with two blips or 90mm overall.
Re: Doc Mod Drivers
Posted: Thu Jul 20, 2017 11:54 pm
by Quarknosis
Dr Bunsen Honeydew wrote: ↑Thu Jul 20, 2017 5:28 pm
Faceplate dia 110mm - hole dia 70mm with two blips or 90mm overall.
Interesting, the drivers that I have already also have a 110mm faceplate if I remember correctly, they were bought cheaply several years ago while I was visiting Australia, probably of Chinese origin. I had to file out a couple of spaces to fit them into the existing hole.
They don't sound too bad as they are but I am sure that they could be improved upon.
Re: Doc Mod Drivers
Posted: Sat Oct 21, 2017 8:46 am
by karatestu
Question for anyone who knows.
How long do these drivers take to run in fully ?
I am not sure how many hours I have put on mine, the big 12" have had less than the 5" as I had little cabs running for longer than with the bass cube added.